Forms

This installation checklist is used by a certifier to perform LG brake testing and it can be completed in either of 2 ways
Method 1
Download the PDF and return the form by clicking on the blue Download button
Method 2
If you are a Certification Applicant select the link below to complete the online version of the form
Form will be migrated to your Evidence Portfolio after it has been assessed by the Engineer.

Online Brake Assessment Form

Suspension and ride height checklist is filled out by the owner before certification

This Printable only version of the Application Assessment needs to be filled out and returned to MDAE 
if you need assistance please contact Mark Dewhurst or use the Messages system by clicking on the envelope icon and leaving a message.

Checklist for both Passenger and commercial vehicles for ADR42, 43 & 44

Forms for completing classic conditional registration 

Forms for Historic Registration in NSW

Welding Declaration Template.

LV conversion Checklist

LH2 Roof Conversion Checklist

This checklist is used by a certifier to perform brake testing
only the certifier signs the bottom of each page

LG2 Brake system conversion checklist

LG1 Brake system Conversion design change checklist

LS4 Front suspension and steering modification checklist

LS3 Front suspension and steering modification design change checklist

LA2 Checklist performance engine
more than 20% power increase

LB1 Transmission and check list

LH6 Vehicle Construction checklist

LH5 Vehicle construction change checklist

LS6 rear suspension/axel checklist

LS5 rear suspension/axel design change checklist

LK1 Seat and Seatbelt checklist

LM1 Fuel tank installation checklist

This checklist outlines procedures and minimum requirements for testing noise emissions of motor vehicles using stationary noise tests. It applies to both modified and individually constructed vehicles

This modification code covers the installation of non original equipment engines with not more than 20% greater mass and/or power output than engines offered by the vehicle’s first manufacturer as a standard or optional engine.

Code LA1 does not apply to ADR category L-Group vehicles and motorcycles.

MODIFICATIONS COVERED UNDER CODE LA1
The following modifications may be performed under Code LA1:
Fitting of a replacement engine with not more than 20% greater mass and/or power output than engines offered by the first manufacturer as a standard or optional engine.

MODIFICATIONS NOT COVERED UNDER CODE LA1
The following is a summary of the modifications that may not be performed under Code LA1:
Fitting of a replacement engine that does not comply with the applicable ADRs;
Fitting of a replacement engine of which the specifications are not suitable for use with the existing components of the vehicle; and
Fitting of a replacement engine that necessitates substantial modification to the vehicle’s structure (e.g. firewall, chassis modifications) or where any structural changes compromise the vehicle’s ability to continue to comply with the occupant protection ADRs.

This checklist is called up by Code LO1 of Section LO Vehicle Standards Compliance and is
intended to assist. The checklist applies to Second Edition ADR category vehicles only.